Shifting issues
4 posters
Midwest240sx :: Forums :: Technical
Page 1 of 1
Shifting issues
Has anyone experienced your 240 not shifting into gear. I have notice over the last 300-500 miles that the 240 was getting difficult to shift into gear, now it will not go into gear at all. I have a 5 spd with around 125 k on it. about the last 5 k is what I have put on the trans..no probs with it. I have a new clutch master, new slave cyl. braided clutch line, eliminated the BS slave box, Fidanza 6-puck clutch and Fidanza light weigh flywheel and megan short shifter...everything is new with 1000 miles to date...Ive adjusted the clutch pedal a few different points still will not go into gear while engine is running. Ive tried all 5 gears along with reverse no go... it will go in w/o engine running of course. Any one had probs like this or heard anything...let me know
Thanks....
Thanks....
yamaproject- Number of posts : 38
Location : Quad Cities
Vehicle : 91 sil-80
Registration date : 2009-04-07
Re: Shifting issues
Yes it was bled correctly and the clutch was broke in properly. A friend of mine think that it maybe in the pressure plate.
yamaproject- Number of posts : 38
Location : Quad Cities
Vehicle : 91 sil-80
Registration date : 2009-04-07
Re: Shifting issues
New thow out bearing, Throw out fork is in good condition not bent or anything and good stream of fluid, I am going to throw in the stock disc and pressure plate and see where that takes me..
yamaproject- Number of posts : 38
Location : Quad Cities
Vehicle : 91 sil-80
Registration date : 2009-04-07
Re: Shifting issues
Yes it works great.
yamaproject- Number of posts : 38
Location : Quad Cities
Vehicle : 91 sil-80
Registration date : 2009-04-07
Midwest240sx :: Forums :: Technical
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|