Midwest240sx
Would you like to react to this message? Create an account in a few clicks or log in to continue.

STOP WASTING YOUR FUCKING MONEY, IDIOTS


Anyone with a KA flywheel on hand?

2 posters

Midwest240sx :: Forums :: Technical

Go down

Anyone with a KA flywheel on hand? Empty Anyone with a KA flywheel on hand?

Post by stagen Sun Sep 26, 2010 10:45 pm

Need some help with some project research if anyone has a KA flywheel at their disposal and willing to take a couple minutes to make two quick measurements.

Anyone with a KA flywheel on hand? Fidanza

Measurement 1: Inside to inside of two bolt holes

Measurement 2: Outside to outside of two bolt holes
stagen
stagen

Number of posts : 36
Age : 33
Location : Chippewa Falls, WI
Vehicle : '96 240sx SE
Registration date : 2010-03-01

Back to top Go down

Anyone with a KA flywheel on hand? Empty Re: Anyone with a KA flywheel on hand?

Post by phezero Mon Sep 27, 2010 2:13 pm

checked mine, got an inside measurement of 3/4" and an outside measurement of 1 3/4". hope that helps

phezero

Number of posts : 1
Registration date : 2010-08-08

Back to top Go down

Back to top

- Similar topics

Midwest240sx :: Forums :: Technical

 
Permissions in this forum:
You cannot reply to topics in this forum