NEEd help crank no start
+2
iroc2
nismo03
6 posters
Midwest240sx :: Forums :: Technical
Page 1 of 1
NEEd help crank no start
Need some help guys me and my buddy put in a mishimoto radiator and everything was going fine my buddy decided itd be a good idea to burp the coolant in well my car ran just fine for all of about 20 mins because coolant shot everywhere!!! my car died and i wasnt get shit no spark or fuel i replaced the dizzy and the car started getting fuel but i am still getting no spark!! ne help would be greatly apprieciated
nismo03- Number of posts : 109
Age : 35
Location : Woodridge
Vehicle : 93 240sx
Registration date : 2010-01-28
Re: NEEd help crank no start
did you try the wires yet? like do you know if they are still good?
iroc2- Number of posts : 465
Age : 33
Location : Lansing Il
Registration date : 2009-07-28
Re: NEEd help crank no start
Maybe I could help if I knew what a dizzy is.
600SX- Number of posts : 72
Age : 43
Location : Twin Lakes, WI
Vehicle : 96 240SX
Registration date : 2009-03-01
Re: NEEd help crank no start
distributor,,, it has a hall effect sensor inside used for cam position
rps1392- Number of posts : 91
Vehicle : 92 240sx
Registration date : 2010-04-22
Re: NEEd help crank no start
Is the coil good?
600SX- Number of posts : 72
Age : 43
Location : Twin Lakes, WI
Vehicle : 96 240SX
Registration date : 2009-03-01
Re: NEEd help crank no start
hahaha. i'm guessing that the coolant shooting everywhere caused a short in a circuit, which caused it to die. probably fried your ecu doing that. or just wait for all the nook and crannies to dry up.
X1nom3D- Number of posts : 57
Location : Wisconsin
Vehicle : Red 91 FB
Registration date : 2009-09-14
Re: NEEd help crank no start
It looks like you fried something with that coolant so first of all check or fuses just make sure its dry, coolant don't dry fast like water so use a air compressor or leaf blower to get everything out worst case or wires are fried or ecu bit the engine cranks just no spark seems like its something else.
Number one rule whenever you work on a car disconnect the battery trust me its a rule for a reason.
another thing when you replace a radiator you have to bleed the air out when its cold when it worms up you will start getting bubbles then when its hot only coolant will come out then you're done. Never open a bleeder when coolant is hot it will burst and burn you shitless.
good luck.
Number one rule whenever you work on a car disconnect the battery trust me its a rule for a reason.
another thing when you replace a radiator you have to bleed the air out when its cold when it worms up you will start getting bubbles then when its hot only coolant will come out then you're done. Never open a bleeder when coolant is hot it will burst and burn you shitless.
good luck.
kg300zxtt- Number of posts : 87
Age : 37
Location : Chicago
Vehicle : 98 S14--95 s14 KA power
Registration date : 2010-01-28
Re: NEEd help crank no start
the car slowely died out,, and i told the kid to bleed it with the bleeder screw but,, his "burb the coolant" was the easiest way..
the whole interior is gutted dash is out all wires and fuses are perfect,
and the coil is good i highly doubt it's the ecu
ima try a few more things , cause this car is pissing me off everytime we get something working another thing takes a shit
thanks for the advice keep it coming
the whole interior is gutted dash is out all wires and fuses are perfect,
and the coil is good i highly doubt it's the ecu
ima try a few more things , cause this car is pissing me off everytime we get something working another thing takes a shit
thanks for the advice keep it coming
rps1392- Number of posts : 91
Vehicle : 92 240sx
Registration date : 2010-04-22
Re: NEEd help crank no start
I also had a problem with no spark and after a while it was a stupid ground connection i cleaned it than started right up but timming was way off cause i took the distributor out. It seems when you do something you always do something else wrong. Thats a 240 way. Amen
kg300zxtt- Number of posts : 87
Age : 37
Location : Chicago
Vehicle : 98 S14--95 s14 KA power
Registration date : 2010-01-28
Re: NEEd help crank no start
ok ill check them all chances are they are bad,, but the things that gets us upset is that it ran fine for like 15 mins then just died
thanks for the help
thanks for the help
rps1392- Number of posts : 91
Vehicle : 92 240sx
Registration date : 2010-04-22
Similar topics
» (ka24e) cant get a click to start
» (Code 11) Crank Angle Sensor| Any help?
» time to start the 240
» Ka wont start
» Sohc ka wont start. help please.
» (Code 11) Crank Angle Sensor| Any help?
» time to start the 240
» Ka wont start
» Sohc ka wont start. help please.
Midwest240sx :: Forums :: Technical
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum